To top it all, checking the sensor today, I now need to get the tracking done as the inside tread on the newish front tyres is more worn than the outside!!īegining to think the car is unlucky. Suffice it to say, the Tigra is not the same shape it used to be, and the A2 is now missing some paint on the front bumper! (at least it is a tough little car!). Also called the brake pad wear warning light, if this symbol shows up it means a sensor has. It's not been my week, my girlfriend curbed the tyre at the weekend, and last night a young blonde in a Tigra pulled out from a junction leaving me about 3 feet to stop on a wet road at 20mph. Not sure what that symbol on your Audi dashboard means. If the wires are not touching, and the light is still on, what else could it be? Didn't think it needed a reset. It goes without saying that the brakes are perhaps the most important part of your vehicle, and if they’re malfunctioning, or the systems that are supporting. But if it’s your brake notification, you should address the issue sooner rather than later. Having a dashboard light stuck in the on position in your dashboard sure can be annoying. So technically, if the wires have been cut off, it is unlikely that they will be in contact with each other (possible, but not probable), so why is the orange symbol still being shown? It's the one in the DIS where the temperature is normally shown. This article applies to the Audi A6 C6 (2005-2016).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |